SmartSwitch™ 2.0
The S3 Series are the world’s first and only hand held lasers equipped with SmartSwitch ™ technology.
SmartSwitch ™ combines both safety and intelligence by requiring the user to follow a protocol of simple clicks and click/ holds to operate the device.
Once unlocked, the laser runs in low power strobe mode (18Hz strobe) which is the default setting designed for safety.
To prevent accidental and unauthorized use the laser has to be unlocked with a software key input after clicking the power switch on the tailcap.
The SmartSwitch™ system exceeds all FDA safety requirements for Class IV lasers and places Wicked Lasers at the forefront of laser product safety feature technology.
The SmartSwitch™ system exceeds all FDA safety requirements for Class IV lasers and places Wicked Lasers at the forefront of laser product safety feature technology.
Once the power is on, the user can toggle between the different active modes all available in low power and high power: Strobe, Constant wave, SOS and Beacon mode with a few simple clicks.
There is also the Tactical hibernation mode which allows you to shut off the laser and quickly re- enable it with the last setting it was on.
The following 9 modes are enabled by using the SmartSwitch 2.0 ™:
There is also the Tactical hibernation mode which allows you to shut off the laser and quickly re- enable it with the last setting it was on.
The following 9 modes are enabled by using the SmartSwitch 2.0 ™:
- Strobe Mode (Hi / Low)
- Constant Wave (Hi / Low)
- SOS (Hi / Low)
- Beacon (Hi / Low)
- Tactical Hibernation Mode
After unlocking your laser, you can select among the active modes by using one of these following codes when pressing the button:
- A long hold (holding down briefly for less than a second) cycles between high power and low power.
- A short hold cycles Strobe mode to Constant Wave mode.
- Clicking 3 times within 2 seconds goes into SOS mode.
- From SOS mode, one quick press will change it into Beacon mode.
- From Beacon mode, one quick press will change it to low power Strobe mode.
- Holding the switch for 3 seconds will go to Tactical Hibernation mode. The middle LED will be flashing to indicate this.
